I have finally have my Kossel printer setup on a Panda M4 and the prints are better then from the MKS sbase that it replaced. But I have two small issues. The upload speed through ESP3D-WEBUI is slow and there is no progress indicator when printing. Is there a way to speed up the upload speed and how do people monitor the print progress other then sending M27.
top of page
bottom of page
it will be nice if you would like to share more about your printer E.g some picture.
that's great! I have send board to the ESP3D-WEBUI team, they are doing this, hope they can increase the speed and add more UI as you saied progress when printing.