i Just wanted to ask if anybody ever tried to update an ultimer 2 with this board?
which drivers / which option would be the best for this application?
top of page
To see this working, head to your live site.
Anyone ever tried to update an Ultimaker 2 (UM2)?
Anyone ever tried to update an Ultimaker 2 (UM2)?
1 comment
Like
Comments (1)
bottom of page
I haven’t tried updating an Ultimaker 2 with the PandaPi board myself, but I’ve seen a few makers discuss similar setups in forums. It usually comes down to matching the right stepper drivers and making sure firmware is configured properly for the board. Some even share that it takes a bit of trial and error to get everything smooth. Sometimes I think about whether to pay someone to article writing services. Still, the hands-on learning always feels worth it.