Hello,
i wired everything like on that pretty Github documentation and Printer seems like running.
But without "Endstop Sensors"
i just invert the Endstop settings on <IP>:8181 and tried again.
But Motor Controll doesnt STOP or react on ENDSTOP switch.
X,Y,Z Endstop without reaction.
Wiring checked again and looks good
any idea what i could check or is there an place for Check the Endstop manual ?
(SW IO check with display the Status)
hello,if you use TMC2209 without UART mode check the diag pin that should not plug in.