Is there a way to change the speed of the fan1 on the M4 board. The command M106 P1 S128? The cooling on my hotend is a little to much so would like to dial it back a bit.
top of page
To see this working, head to your live site.
Comments (1)
Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page
add the following line into the pins_PANDA_M4.h
and then compile&upload firmware again
#define FAN1_PIN 119 // this is the FAN1 on the board. M106: Set Fan Speed 0~255,M107: Fan Off. E.g "M106 P1 S255"
after that you can see the FAN1 menu in the screen if you use the LCD12864.