Looking at upgrading to pandapi 2.8 for my Qidi Tech 1 (Its been a good printer, but need some better features, and Qidi won't give out firmware)
It has these drivers:
They look to have identical pinouts to the A4988 (just have to rotate and read upside down), but want to know if you think they will work.
yeah, you can try to reverse one stepper as that way.
Was able to successfully reverse all the pins, it took forever! I snipped the plastic between the pins so I could remove them individually, then added new pin rows.
Yes, the same pins as you said, but the pins need to be soldered and turned upside down, which is not easy.